Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
- 11. Suspension bracket
   11.1. Introduction
   11.2. Technical characteristics
   + 11.3. The lobby is resistant
   - 11.4. Rack of a back suspension bracket
      11.4.1. Back stabilizer of cross stability
      11.4.2. Longitudinal lever of a back suspension bracket
      11.4.3. Cross levers of a back suspension bracket
      11.4.4. Nave of a back suspension bracket
      11.4.5. Fastener of a back nave
   11.5. The air self-leveled suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


2d841be8


11.4.3. Cross levers of a back suspension bracket

Removal

PERFORMANCE ORDER
1. Lift a back part of the car and record on supports. Remove a back wheel.
2. On models 2WD remove a back part of the exhaust system.
3. On models with ABS remove a sensor wire from the longitudinal lever of a back suspension bracket.
4. Using a marker or paint, apply combination tags on a back adjusting bolt of the cross lever and a back beam.
5. Unscrew draft of the stabilizer from the back cross lever.
6. Unscrew a nut and take a bolt of fastening of cross levers to the nave fastener.
7. Unscrew nuts and take bolts of fastening of the internal ends of cross levers to a back beam.

Installation

PERFORMANCE ORDER
Installation is made in the sequence, the return to removal. You make tightening of bolts and nuts of fastening of cross levers of a back suspension bracket after installation of the car on wheels. Check and, if necessary, adjust the angles of installation of back wheels.