Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
- 11. Suspension bracket
   11.1. Introduction
   11.2. Technical characteristics
   + 11.3. The lobby is resistant
   - 11.4. Rack of a back suspension bracket
      11.4.1. Back stabilizer of cross stability
      11.4.2. Longitudinal lever of a back suspension bracket
      11.4.3. Cross levers of a back suspension bracket
      11.4.4. Nave of a back suspension bracket
      11.4.5. Fastener of a back nave
   11.5. The air self-leveled suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


2d841be8


11.4.5. Fastener of a back nave

Removal

PERFORMANCE ORDER
1. On models 4WD weaken a nut of fastening of a back power shaft to a nave.
2. Lift a back part of the car and record on supports. Remove a back wheel.
3. On models with back brake drums remove the brake drum, brake shoes, disconnect a brake tube from the working brake cylinder and remove the brake cylinder.
4. On models with back disk brakes remove a support and, using a soft wire, suspend it to a back rack, remove the holder of a support, a brake disk and knot of the emergency brake.
5. Separate a cable of the emergency brake from a brake board.
6. On models with ABS unscrew a bolt and remove the ABS sensor.
7. On models 2 WD remove a cap from the central part of a nave. Unscrew a nut of fastening of a nave and remove a back nave.
8. Unscrew 4 bolts and remove a brake board from the nave fastener.
9. Unscrew the longitudinal lever of a back suspension bracket from the nave fastener.
10. Disconnect cross levers of a back suspension bracket from the nave fastener.
11. Unscrew bolts of fastening of a back rack to the nave fastener.
12. Remove the nave fastener. On models 4WD unscrew a nut of fastening of a back power shaft to a nave and take a power shaft from a nave.

Installation

PERFORMANCE ORDER
Installation is made in the sequence, the return to removal. Tighten the required moment bolts and nuts of fastening of levers of a back suspension bracket after installation of the car on wheels. On models with back brake drums remove air from the hydraulic brake system.