+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
- 11. Suspension bracket
11.2. Technical characteristics
+ 11.3. The lobby is resistant
+ 11.4. Rack of a back suspension bracket
11.5. The air self-leveled suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment
Arrangement of elements of the air self-leveled suspension bracket on the car
The scheme of the air self-leveled suspension bracket
1 – electromagnetic valve
2 – electromagnetic valves
3 – dehumidifier
4 – air electromagnetic valve
5 – compressor
6 – air electromagnetic valve of loading
|7 – air receiver
8 – pressure sensor
9 – control unit
10 – suspension bracket rack
11 – diaphragm
12 – car height sensor
13 – air pipeline
Forward and back racks of a suspension bracket with system of self-alignment
1 – nut
2 – plug
3 – sealing ring of round section
4 – самоконтрящаяся nut
5 – fastening of a rack
6 – bracket
7 – sealing ring
8 – corrugated pipe
|9 – bolt
10 – adjusting bolt
11 – washer
12 – electromagnetic valve
13 – laying
14 – an air tube for the electromagnetic valve
15 – air tube
16 – electric socket
Elements of a compressor / osushivatel of system of the self-leveled suspension bracket
||1 – osushivatel
2 – compressor
3 – laying
4 – washer
5 – compressor arm
6 – compressor pipe
Air receiver of system of the self-leveled suspension bracket
Some models are equipped with the air self-leveled suspension bracket which operates clearance of the car. The control switch of height allows to choose one of two levels of clearance – normal or high. Distinction of height between the normal or high level of clearance makes 40 mm.
The system supports constant clearance, changing pressure in the shock-absorber depending on loading of the car on signals from the sensor of height of the car installed in each spring.
The system consists of four racks of a suspension bracket, the air compressor, the air tank, a dehumidifier and pipelines connecting these components.
Service of the air self-leveled suspension bracket needs to be made only at service station.
||During the work on any part of the air self-leveled suspension bracket check that the car is in normal (low) situation, the control switch of height on dashboards is switched off and removed a weight wire from the accumulator.
Replacement of a forward rack
| PERFORMANCE ORDER
|1. Lift a forward part of the car and record on supports. Remove forward wheels.
|2. Disconnect air supply tubes.
|3. Disconnect the electric socket from the car height sensor.
| 4. Other operations on removal and installation of a rack with system of self-alignment are similar to operations on removal and installation of a usual rack.
Removal and installation of the compressor and osushivatel
| PERFORMANCE ORDER
|1. Lift a forward part of the car and record on supports. Remove the left forward wheel.
|2. Remove a forward part of a mudguard.
|3. Disconnect air pipes from an osushivatel.
| 4. Disconnect electric sockets.
|5. Unscrew bolts and nuts of fastening and remove the compressor and an osushivatel.
|6. Installation is made in the sequence, the return to removal.