Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
- 12. Steering
12.1. Introduction
12.2. Technical characteristics
12.3. Steering wheel
12.4. Tips of steering draft
12.5. Replacement of protective covers of steering transfer
12.6. Steering transfer
12.7. Pump of the amplifier of steering
12.8. Removal of air from system of steering with the amplifier
+ 13. Body
+ 14. Electric equipment
|
Elements of fastening of a steering wheel on models without safety cushion
|
|
1 – decorative slip
2 – button of a sound signal
3 – contact plate |
4 – switch cruise control
5 – steering wheel
6 – lower casing |
Removal
Prevention
On models with the safety airbag during the work about sensors of collision of a steering column and the dashboard for an exception of operation of a safety cushion remove a weight wire from the accumulator and wait at least 1 minute before work.
| PERFORMANCE ORDER |
| 1. Establish forward wheels for the movement directly forward. |
|
|
| 2. On models without airbag of safety unscrew screws of fastening and remove the button of a sound signal. |
|
3. On models with the safety airbag, unscrew the bolts fixing the safety airbag block to a steering wheel. |
|
4. Remove a safety cushion. |
|
5. Disconnect electric sockets of a safety cushion and sound signal. |
|
6. Unscrew a nut of fastening of a steering wheel. |
|
7. Note the provision of a nave of a steering wheel in relation to a steering shaft. |
|
8. Disconnect the electric socket of system a cruise control. |
|
9. Using a special stripper, remove a steering wheel from a shaft. |
|
Installation
| PERFORMANCE ORDER |
| Installation is made in the sequence, the return to removal. Check that combined a tag on a nave of a steering wheel with a tag on the helmsman to a shaft. |
|
|
|
