Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
- 14. Electric equipment
   - 14.1. Body electric equipment
      14.1.1. Introduction
      14.1.2. Electric chains
      14.1.3. Detection of not closed chain
      14.1.4. Safety locks
      14.1.5. Chain breakers
      14.1.6. Relay
      14.1.7. Relay of turns and alarm light system
      14.1.8. Multipurpose switches of a steering column
      14.1.9. Ignition lock
      + 14.1.10. Replacement of switches of the dashboard
      14.1.11. Combination of devices
      14.1.12. Radio receiver
      14.1.13. Loudspeakers
      14.1.14. Antenna
      14.1.15. The antenna with the electric drive
      14.1.16. Replacement of bulbs of headlights
      14.1.17. Adjustment of light of headlights
      14.1.18. Headlight
      14.1.19. Replacement of bulbs of an incandescence
      14.1.20. Screen wiper engine
      14.1.21. Sound signal
      14.1.22. Check of a heater of back glass
      14.1.23. Window regulators with the electric drive
      14.1.24. Rear-view mirrors with the electric drive
      14.1.25. Safety airbag
   + 14.2. Electrical circuitries


2d841be8


14.1.14. Antenna

PERFORMANCE ORDER
1. Disconnect the antenna plug from the radio receiver. Tie a thin long cord to the antenna plug and exempt an antenna wire from fastening brackets under the dashboard.
2. Unscrew screws of fastening of the antenna.
3. Lift the antenna up after unscrewing of screws of fastening.
4. Having pulled for the antenna, take an antenna wire from the car.
5. Untie a cord from the plug of the antenna and leave it in the car.
6. Tie the plug of the new antenna to a cord and for a cord tighten the antenna plug together with a wire in the car.
7. Fix an antenna wire by brackets to the dashboard and untie a cord from the antenna plug.
8. Connect the antenna plug to the radio receiver.