Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   5.1. Introduction
   5.2. Technical characteristics
   5.3. Removal of pressure in fuel system
   5.4. Check of the fuel pump
   5.5. Fuel pump
   5.6. Fuel separator (only models 4WD)
   5.7. Fuel level sensor
   5.8. Fuel tank
   5.9. Casing of the air filter
   5.10. Accelerator cable
   5.11. Electronic system of injection of fuel
   5.12. Fuel system
   5.13. System of air supply
   5.14. System of electronic control
   5.15. Check of system of injection of fuel
   + 5.16. Check and replacement of elements of system of injection of fuel
   5.17. Turbocharger
   5.18. Check of the executive mechanism of the gate of a turbocharger
   5.19. General check of a turbocharger
   5.20. Removal and installation of a turbocharger
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


2d841be8


5.5. Fuel pump

GENERAL INFORMATION

Removal of percussion caps of fastening of a carpet for access to a cover of the fuel pump


Arrangement of the fuel level sensor and block of the sensor of level of fuel / the fuel pump on models 4WD


Removal and installation

PERFORMANCE ORDER
1. Take off pressure in fuel system. Remove a weight wire from the accumulator.
2. Remove a back seat (the car with a body like "sedan") or a carpet (the car with a body "station wagon") for access to a cover of the fuel pump (see rice. Removal of percussion caps of fastening of a carpet for access to a cover of the fuel pump, rice. An arrangement of the fuel level sensor and block of the sensor of level of fuel / the fuel pump on models 4WD).
3. Unscrew screws of fastening of a cover of the fuel pump and lift a cover.
4. Disconnect the electric socket of the fuel pump.
5. Weaken collars and remove hoses from unions of the fuel pump. On models 4WD also remove a hose of the pumping-over pump.
6. Unscrew bolts of fastening of the fuel pump.
7. Take assembly of the fuel pump from the fuel tank.
8. Disconnect the internal electric socket.
9. Remove a fuel-supply line.
10. Release fastening and remove the fuel pump.
10. Installation is made in the sequence, the return to removal.