Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   5.1. Introduction
   5.2. Technical characteristics
   5.3. Removal of pressure in fuel system
   5.4. Check of the fuel pump
   5.5. Fuel pump
   5.6. Fuel separator (only models 4WD)
   5.7. Fuel level sensor
   5.8. Fuel tank
   5.9. Casing of the air filter
   5.10. Accelerator cable
   5.11. Electronic system of injection of fuel
   5.12. Fuel system
   5.13. System of air supply
   5.14. System of electronic control
   5.15. Check of system of injection of fuel
   + 5.16. Check and replacement of elements of system of injection of fuel
   5.17. Turbocharger
   5.18. Check of the executive mechanism of the gate of a turbocharger
   5.19. General check of a turbocharger
   5.20. Removal and installation of a turbocharger
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


2d841be8


5.9. Casing of the air filter

GENERAL INFORMATION

Air filter

1 – air filter
2 – cover of the air filter
3 – bracket
4 – air stream sensor
5 – the filtering element of the air filter
6 – laying
7 – rubber support
8 – laying
9 – casing of the air filter
10 – arm
11 – sealing ring

The air filter of the engine with a turbocharger

1 – laying
2 – resonator
3 – air filter
4 – collar
5 – air inlet pipe
6 – collar
7 – sealing ring
8 – bracket
9 – camera of the resonator
10 – ventilating hose
11 – collar
12 – hose of the bypass valve
13 – hose of the valve of ventilation of a case
14 – turbocharger
15 – branch pipe
16 – air bypass valve
17 – a hose to the inlet channel
18 – vacuum hose of the bypass valve
19 – hose
20 – laying
21 – collector casing suspension bracket
22 – throttle
23 – throttle sensor
24 – laying
25 – collector casing

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Remove the filtering element from a casing of the air filter.
3. Weaken a collar on a tube of an air inlet and remove it from a casing of the air filter. Remove the top half of a casing of the air filter together with the measuring instrument of a stream of air and a tube of an air inlet (see rice. Air filter).
4. Unscrew bolts of fastening of a casing of the air filter.
5. Remove a casing of the air filter and take it from a motor compartment.
6. Installation is made in the sequence, the return to removal.