Subaru Legacy
since 1990-1998 release
Repair and operation of the car
Subaru Legacy
+
1.1. Identification numbers
+
2. Maintenance
+
3. Engines
+
4. Heating, ventilation
+
5. Fuel system
-
6. Exhaust system
6.1. Service of final system
-
6.2. Reduction of toxicity of exhaust gases and management of operation of the engine
6.2.1. Technical characteristics
6.2.2. System of self-diagnostics (OBD) and codes
6.2.3. Block of electronic control (ECM)
6.2.4. Sensor of temperature of cooling liquid
6.2.5. Sensor of provision of a butterfly valve
6.2.6. Sensors of a bent shaft, camshaft, car speed
6.2.7. Oxygen sensor
6.2.8. Air stream sensor
6.2.9. Detonation sensor
6.2.10. Pressure sensor in an inlet collector
6.2.11. Replacement of the sensor of temperature of cooling liquid
6.2.12. Replacement of the sensor of a stream of air
6.2.13. Replacement of the sensor of oxygen
6.2.14. Replacement of the sensor of provision of a butterfly valve
6.2.15. Replacement of the sensor of an angle of rotation of a bent shaft
6.2.16. Replacement of the sensor of position of the camshaft
6.2.17. Replacement of the sensor of a detonation
6.2.18. Replacement of the sensor of speed of the car
6.2.19. Replacement of the sensor of pressure
6.2.20. System of repeated combustion of exhaust gases (EGR)
6.2.21. System of catching of vapors of fuel (EVAP)
6.2.22. System of compulsory ventilation of a case (PCV)
6.2.23. Catalyst
+
7. Systems of start, ignition
+
8. Transmissions
+
9. Coupling, shaft
+
10. Brake system
+
11. Suspension bracket
+
12. Steering
+
13. Body
+
14. Electric equipment
6.2.1. Technical characteristics
GENERAL INFORMATION
Oxygen heater sensor resistance
30 Ohm
Resistance of the sensor of an angle of rotation of a bent shaft
1,000 – 4,000 Ohms
Resistance of the sensor of position of the camshaft
1,000 – 4,000 Ohms
