Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
- 6. Exhaust system
   6.1. Service of final system
   - 6.2. Reduction of toxicity of exhaust gases and management of operation of the engine
      6.2.1. Technical characteristics
      6.2.2. System of self-diagnostics (OBD) and codes
      6.2.3. Block of electronic control (ECM)
      6.2.4. Sensor of temperature of cooling liquid
      6.2.5. Sensor of provision of a butterfly valve
      6.2.6. Sensors of a bent shaft, camshaft, car speed
      6.2.7. Oxygen sensor
      6.2.8. Air stream sensor
      6.2.9. Detonation sensor
      6.2.10. Pressure sensor in an inlet collector
      6.2.11. Replacement of the sensor of temperature of cooling liquid
      6.2.12. Replacement of the sensor of a stream of air
      6.2.13. Replacement of the sensor of oxygen
      6.2.14. Replacement of the sensor of provision of a butterfly valve
      6.2.15. Replacement of the sensor of an angle of rotation of a bent shaft
      6.2.16. Replacement of the sensor of position of the camshaft
      6.2.17. Replacement of the sensor of a detonation
      6.2.18. Replacement of the sensor of speed of the car
      6.2.19. Replacement of the sensor of pressure
      6.2.20. System of repeated combustion of exhaust gases (EGR)
      6.2.21. System of catching of vapors of fuel (EVAP)
      6.2.22. System of compulsory ventilation of a case (PCV)
      6.2.23. Catalyst
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


2d841be8


6.2.12. Replacement of the sensor of a stream of air

GENERAL INFORMATION

Air stream sensor arrangement

The sensor of a stream of air (MAF) (it is specified by an arrow) is located in an air inlet tube.

PERFORMANCE ORDER
1. Disconnect the electric socket from the sensor.
2. Disconnect the case of the air filter from an air inlet tube.
3. Unscrew nuts and remove the air stream sensor from the air filter.
4. Installation is made in the sequence, the return to removal.