|
Subaru Legacysince 1990-1998 releaseRepair and operation of the car |
|
Subaru Legacy + 1.1. Identification numbers + 2. Maintenance + 3. Engines + 4. Heating, ventilation + 5. Fuel system - 6. Exhaust system 6.1. Service of final system - 6.2. Reduction of toxicity of exhaust gases and management of operation of the engine 6.2.1. Technical characteristics 6.2.2. System of self-diagnostics (OBD) and codes 6.2.3. Block of electronic control (ECM) 6.2.4. Sensor of temperature of cooling liquid 6.2.5. Sensor of provision of a butterfly valve 6.2.6. Sensors of a bent shaft, camshaft, car speed 6.2.7. Oxygen sensor 6.2.8. Air stream sensor 6.2.9. Detonation sensor 6.2.10. Pressure sensor in an inlet collector 6.2.11. Replacement of the sensor of temperature of cooling liquid 6.2.12. Replacement of the sensor of a stream of air 6.2.13. Replacement of the sensor of oxygen 6.2.14. Replacement of the sensor of provision of a butterfly valve 6.2.15. Replacement of the sensor of an angle of rotation of a bent shaft 6.2.16. Replacement of the sensor of position of the camshaft 6.2.17. Replacement of the sensor of a detonation 6.2.18. Replacement of the sensor of speed of the car 6.2.19. Replacement of the sensor of pressure 6.2.20. System of repeated combustion of exhaust gases (EGR) 6.2.21. System of catching of vapors of fuel (EVAP) 6.2.22. System of compulsory ventilation of a case (PCV) 6.2.23. Catalyst + 7. Systems of start, ignition + 8. Transmissions + 9. Coupling, shaft + 10. Brake system + 11. Suspension bracket + 12. Steering + 13. Body + 14. Electric equipment |
6.2.7. Oxygen sensor
The sensor of oxygen measures the content of oxygen in a stream of exhaust gases. The sensor of oxygen reports about the content of oxygen in exhaust gases by means of the output tension which can change from size 0,1 B (high content of oxygen, poor mix), up to the size of 0,9 V (small content of oxygen, rich mix). On the basis of an oxygen sensor signal the ECM block changes a proportion of fuel-air mix, operating duration of an impulse of opening of fuel nozzles. The proportion of mix of 14,7 parts of air on 1 part of fuel is ideal for the minimum content of harmful substances in exhaust gases. This proportion ensures the most effective functioning of the catalyst. On the sensor of oxygen there is no output tension if its temperature is lower than the normal working temperature which is equal to 320 °C. During warming up of the sensor of oxygen the ESM block works in the mode of the broken-off electric chain. Check |
|