Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
- 7. Systems of start, ignition
   7.1. Introduction
   7.2. Technical characteristics
   7.3. Check of the accumulator
   7.4. Accumulator charging
   7.5. Accumulator
   + 7.6. System of ignition
   + 7.7. System of charging
   + 7.8. System of start of the engine
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


2d841be8


7.4. Accumulator charging

GENERAL INFORMATION

Accumulator charging has to be made when the accumulator is removed from the car.

You make accumulator charging charging current from 3.5 to 4 amperes and until electrolyte density in the accumulator does not increase within 4 hours.

Use of big currents for bystry accumulator charging is not recommended since in this case there can be a buckling of plates because of an overheat.

During accumulator charging temperature of electrolyte should not exceed 37.8 °C.