Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
- 9. Coupling, shaft
   9.1. Technical characteristics
   - 9.2. Coupling
      9.2.1. Coupling cable
      9.2.2. Main cylinder of coupling
      9.2.3. Working cylinder of coupling
      9.2.4. Clutch plate
      9.2.5. Release bearing
      9.2.6. Replacement of the needle bearing of an output shaft of the transmission
      9.2.7. Removal of air from hydraulic system of coupling
      9.2.8. The switch of blocking of a starter on a coupling pedal
   + 9.3. Driveshaft
   + 9.4. Power shafts
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


2d841be8


9.2.1. Coupling cable

GENERAL INFORMATION

Check of a free wheeling of a pedal of coupling

Check

For check of adjustment of a cable of coupling, check a free wheeling of a pedal of coupling. The free wheeling of a pedal of coupling is the course of a pedal from a starting position until emergence of noticeable resistance when pressing a pedal. If the free wheeling of a pedal of coupling does not conform to requirements, make adjustment of a cable of coupling.

Adjustment

PERFORMANCE ORDER
1. Disconnect a returnable spring from a coupling switching off fork.
2. Weaken a lock-nut on the end of a cable of coupling in a coupling switching off fork.
3. Rotating an adjusting nut, adjust a free and full speed of a fork of switching off of coupling.
4. Tighten a lock-nut.
5. Establish a returnable spring on a coupling switching off fork.

Replacement

PERFORMANCE ORDER
1. Remove a returnable spring from a coupling switching off fork.
2. Unscrew a lock-nut and an adjusting nut since the end of a cable of coupling.
3. By means of flat-nose pliers remove an U-shaped bracket which fixes a coupling cable cover to an arm.
4. Remove a coupling cable from an arm.
5. In interior of the car on the top part of a pedal of coupling remove the forelock (2), take a pin (1) and remove a cable of coupling (3) from a coupling pedal.
6. Take a coupling cable through a partition of a motor compartment in a motor compartment.
7. Installation is made in the sequence, the return to removal. Adjust a coupling cable.