Subaru Legacy

since 1990-1998 release

Repair and operation of the car

Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
- 9. Coupling, shaft
   9.1. Technical characteristics
   - 9.2. Coupling
      9.2.1. Coupling cable
      9.2.2. Main cylinder of coupling
      9.2.3. Working cylinder of coupling
      9.2.4. Clutch plate
      9.2.5. Release bearing
      9.2.6. Replacement of the needle bearing of an output shaft of the transmission
      9.2.7. Removal of air from hydraulic system of coupling
      9.2.8. The switch of blocking of a starter on a coupling pedal
   + 9.3. Driveshaft
   + 9.4. Power shafts
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment

9.2.3. Working cylinder of coupling

Removal

PERFORMANCE ORDER

1. Remove a weight wire from the accumulator.

2. Lift the car and record on supports.

3. Unscrew a bolt and remove a hydraulic hose from the working cylinder of coupling. Merge brake fluid in a suitable container.

4. Unscrew bolts and remove the working cylinder of coupling.

Installation

PERFORMANCE ORDER

1. Install the working cylinder of coupling on a coupling case. Check that the pusher was established in dredging of a fork of switching off of coupling.

2. Using new sealing washers, connect a hydraulic hose to the working cylinder of coupling.

3. Fill the main cylinder of coupling with brake fluid.

4. Remove air from hydraulic system of coupling.

5. Lower the car and connect a weight wire to the accumulator.