Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
- 9. Coupling, shaft
   9.1. Technical characteristics
   - 9.2. Coupling
      9.2.1. Coupling cable
      9.2.2. Main cylinder of coupling
      9.2.3. Working cylinder of coupling
      9.2.4. Clutch plate
      9.2.5. Release bearing
      9.2.6. Replacement of the needle bearing of an output shaft of the transmission
      9.2.7. Removal of air from hydraulic system of coupling
      9.2.8. The switch of blocking of a starter on a coupling pedal
   + 9.3. Driveshaft
   + 9.4. Power shafts
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


2d841be8


9.2.6. Replacement of the needle bearing of an output shaft of the transmission

GENERAL INFORMATION

The needle bearing of an entrance shaft of the transmission is installed in an end face of a bent shaft.

PERFORMANCE ORDER
1. Remove the transmission.
2. Remove the leading part of coupling and a clutch plate.
3. Take from an opening in an end face of a bent shaft the needle bearing by means of the corresponding stripper.
4. Using a tubular mandrel of the corresponding diameter, install the new needle bearing in an opening in an end face of a bent shaft.
5. Establish a clutch plate and press a disk. Install the transmission.