Subaru Legacy

since 1990-1998 release

Repair and operation of the car

Subaru Legacy
+ 1.1. Identification numbers
- 2. Maintenance
   2.1. Introduction
   2.2. Technical characteristics
   2.3. Frequency of service
   2.4. Check of level of engine oil
   2.5. Level of cooling liquid
   2.6. Level of brake fluid and liquid of the drive of coupling
   2.7. Liquid for a windshield washer
   2.8. Check of the accumulator
   2.9. Tires and check of pressure in tires
   2.10. Check of level of oil in the automatic transmission
   2.11. Check of level of liquid in the amplifier of steering
   2.12. Replacement of oil and oil filter
   2.13. Check and service of the accumulator
   2.14. Accumulator charging
   2.15. Check of the cooling system
   2.16. Check of hoses, tubes and their replacement
   2.17. Check and replacement of brushes of screen wipers
   2.18. Shift of tires
   2.19. Check of a suspension bracket and steering
   2.20. Check of the exhaust system
   2.21. Check of level of oil in the transmission and the main transfer
   2.22. Check of level of oil in differential (the main transfer)
   2.23. Check of the brake system
   2.24. Check of the vacuum amplifier of brakes
   2.25. Check of the emergency brake
   2.26. Check of fuel system
   2.27. Replacement of the fuel filter
   2.28. Check and replacement of a driving belt
   2.29. Check of a free wheeling of a pedal of a brake
   2.30. Check of a free wheeling of a pedal of coupling
   2.31. Check and replacement of spark plugs
   2.32. Check of high-voltage wires
   2.33. Check and adjustment of turns of idling
   2.34. Replacement of the air filter
   2.35. Check and replacement of the valve of ventilation of a case (PCV)
   2.36. Check of system of catching of vapors of fuel
   2.37. Check of system of repeated combustion of exhaust gases (EGR)
   2.38. Service of the cooling system
   2.39. Replacement of brake fluid
   2.40. Replacement of oil in the automatic transmission
   2.41. Replacement of oil in the mechanical transmission
   2.42. Check and adjustment of gaps of valves
   + 2.43. Main malfunctions
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment

2.35. Check and replacement of the valve of ventilation of a case (PCV)

GENERAL INFORMATION

The valve (PCV) is located in an inlet collector.

PERFORMANCE ORDER

1. Switch off the engine and remove a hose of ventilation of a case from the PCV valve.
	2. Start the engine and install a hand finger on the valve. During the operation of the engine vacuum which increases at increase in turns of the engine has to be felt.
3. After removal of a finger from the valve the valve has to open, at the same time it will make the clicking sound.
4. If the valve does not work, unscrew it from an inlet collector.
5. Install the new valve of ventilation of a case and establish on it a hose.