Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
- 2. Maintenance
   2.1. Introduction
   2.2. Technical characteristics
   2.3. Frequency of service
   2.4. Check of level of engine oil
   2.5. Level of cooling liquid
   2.6. Level of brake fluid and liquid of the drive of coupling
   2.7. Liquid for a windshield washer
   2.8. Check of the accumulator
   2.9. Tires and check of pressure in tires
   2.10. Check of level of oil in the automatic transmission
   2.11. Check of level of liquid in the amplifier of steering
   2.12. Replacement of oil and oil filter
   2.13. Check and service of the accumulator
   2.14. Accumulator charging
   2.15. Check of the cooling system
   2.16. Check of hoses, tubes and their replacement
   2.17. Check and replacement of brushes of screen wipers
   2.18. Shift of tires
   2.19. Check of a suspension bracket and steering
   2.20. Check of the exhaust system
   2.21. Check of level of oil in the transmission and the main transfer
   2.22. Check of level of oil in differential (the main transfer)
   2.23. Check of the brake system
   2.24. Check of the vacuum amplifier of brakes
   2.25. Check of the emergency brake
   2.26. Check of fuel system
   2.27. Replacement of the fuel filter
   2.28. Check and replacement of a driving belt
   2.29. Check of a free wheeling of a pedal of a brake
   2.30. Check of a free wheeling of a pedal of coupling
   2.31. Check and replacement of spark plugs
   2.32. Check of high-voltage wires
   2.33. Check and adjustment of turns of idling
   2.34. Replacement of the air filter
   2.35. Check and replacement of the valve of ventilation of a case (PCV)
   2.36. Check of system of catching of vapors of fuel
   2.37. Check of system of repeated combustion of exhaust gases (EGR)
   2.38. Service of the cooling system
   2.39. Replacement of brake fluid
   2.40. Replacement of oil in the automatic transmission
   2.41. Replacement of oil in the mechanical transmission
   2.42. Check and adjustment of gaps of valves
   + 2.43. Main malfunctions
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


2d841be8


2.9. Tires and check of pressure in tires

GENERAL INFORMATION

Measurement of depth of the drawing of a protector of the tire

Depth of the drawing of a protector of tires can be controlled by special adaptation. At achievement of extreme wear of the tire it is necessary to replace.

Uneven wear of tires and the reasons which caused it


 Uneven wear:

– wheels are not balanced or disks of wheels are bent;
 – wear of steering draft;
 – wear of a forward suspension bracket.


Low pressure of air in tires.

High pressure of air in tires.

Wrong positive convergence or big disorder.

Wear because of not coaxiality.

Continuous check of a condition of tires will allow to find in due time intensive wear and to remove its cause that will allow to avoid more serious consequences.

With uneven wear of tires it is necessary to find the reason of it and to eliminate it (see rice. The uneven wear of tires and the reasons which caused it).

PERFORMANCE ORDER
1. Check tires for existence of cuts, punctures and foreign objects in tires.
2. Check reliability of screwing up of a zolotnik.
3. Places of leak of air from the tire can be defined by soapsuds.
4. Carefully survey internal lateral face of each tire on existence of traces of brake fluid.
5. The required pressure in tires prolongs the term of their service therefore it needs to be checked regularly. You make control of pressure in tires only on cold tires.