Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
- 9. Coupling, shaft
9.1. Technical characteristics
- 9.2. Coupling
9.2.1. Coupling cable
9.2.2. Main cylinder of coupling
9.2.3. Working cylinder of coupling
9.2.4. Clutch plate
9.2.5. Release bearing
9.2.6. Replacement of the needle bearing of an output shaft of the transmission
9.2.7. Removal of air from hydraulic system of coupling
9.2.8. The switch of blocking of a starter on a coupling pedal
+ 9.3. Driveshaft
+ 9.4. Power shafts
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment
|
Removal
| PERFORMANCE ORDER |
| 1. Remove the transmission. |
|
|
2. Remove brackets of fastening of the release bearing. |
| |
3. Remove the release bearing from an entrance shaft of the transmission. |
|
4. Having pulled a coupling switching off fork, remove it from a spherical head of a support of the lever. |
|
5. Remove a rubber cover and through an opening in a case of coupling take a coupling switching off fork. |
|
Check
| PERFORMANCE ORDER |
| 1. Holding the bearing for an external holder, pressing, turn an internal holder of the bearing. If the bearing rotates with noise and unevenly, replace the release bearing. |
|
|
2. Wipe the bearing with pure rags and check its state for existence of damages, wear and a crack. Do not wash out the bearing in solvent as it is the bearing of the closed type. |
|
Installation
| PERFORMANCE ORDER |
| 1. Apply high-temperature lubricant on a coupling switching off cylinder pusher head. |
|
|
2. Apply high-temperature lubricant on the directing plug of the release bearing. |
| |
3. Apply high-temperature lubricant on working surfaces of a fork of switching off of coupling. |
| |
4. Apply high-temperature lubricant on a spherical nest of a fork of switching off of coupling. |
| 5. Installation is made in the sequence, the return to removal. |
|
|
|
