Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
- 4. Heating, ventilation
   - 4.1. Cooling system
      4.1.1. Introduction
      4.1.2. Technical characteristics
      4.1.3. Antifreeze
      4.1.4. Check and replacement of the thermostat
      4.1.5. Check and replacement of the fan of a radiator and relay
      4.1.6. Radiator
      4.1.7. Broad tank
      4.1.8. Water pump
      4.1.9. Sensor of temperature of cooling liquid
   + 4.2. System of heating
   + 4.3. Air conditioning system
   4.4. System of climate control
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


2d841be8


4. Heating, ventilation

4.1. Cooling system

4.1.1. Introduction

GENERAL INFORMATION

1 – heater hoses
2 – hose of the air conditioning system
3 – compressor of the air conditioning system
4 – broad tank
5 – radiator stopper
6 – radiator fans
7 – condenser of the air conditioning system
8 – top hose of a radiator
9 – ressiver/dehumidifier

The cooling system of tight type turns on the pump, a radiator, a broad tank, the electric fan of a radiator and the thermostat. At start of the cold engine cooling liquid circulates only around the engine. Heated cooling liquid passes through a radiator of a heater and comes back to the water pump. Intake of cooling liquid through a radiator is closed that provides the closed thermostat. When cooling liquid reaches the predetermined temperature, the thermostat opens and hot cooling liquid passes through a hose to a radiator. As cooling liquid passes through a radiator, there is its cooling with a stream of counter air. The electric fan of a radiator installed behind a radiator is run by the thermal sensor. On models with the air conditioning system the second fan of a radiator is installed. In addition to the ordinary sensor of the index of temperature of cooling liquid temperature sensors for ensuring work systems of injection of fuel and system of ignition are installed.