Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
- 10. Brake system
   10.1. Introduction
   10.2. Technical characteristics
   10.3. Replacement of brake shoes on disk brakes
   10.4. Support of disk brakes
   10.5. Brake disk
   10.6. Replacement of brake shoes of drum brakes
   10.7. Working brake cylinder
   10.8. Main brake cylinder
   10.9. Brake pipelines and hoses
   10:10. Replacement of the regulator of pressure
   10:11. Pumping of the hydraulic brake system
   10:12. Adjustment of the emergency brake
   10:13. Replacement of a cable of the emergency brake
   10:14. Replacement of brake shoes of the emergency brake on back disk brakes
   10:15. Additional brake system
   10:16. Vacuum amplifier of brakes
   10:17. Stoplight switch
   10:18. Anti-blocking system of brakes (ABS)
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


2d841be8


10:13. Replacement of a cable of the emergency brake

GENERAL INFORMATION

Arrangement of cables of the emergency brake


Arrangement of elements of fastening of a cable of the emergency brake under the car


Arrangement of a bolt of fastening of a cable of the emergency brake to a back suspension bracket of the car


PERFORMANCE ORDER
1. Remove the central console.
2. Unscrew a lock-nut and an adjusting nut since the end of a cable of the emergency brake.
3. Lift a back part of the car and record on supports. Remove back wheels.
4. Under the car unscrew bolts of all fastenings of a cable of the emergency brake (see rice. An arrangement of cables of the emergency brake, the Arrangement of elements of fastening of a cable of the emergency brake under the car, the Arrangement of a bolt of fastening of a cable of the emergency brake to a back suspension bracket of the car).
5. Disconnect forward parts of back cables of the emergency brake from the compensator. Unscrew two nuts and remove an arm.
6. On models with drum brakes remove brake shoes and disconnect a cable of the emergency brake from the lever on a brake shoe.
7. On models with back disk brakes remove brake shoes of the emergency brake and disconnect a cable of the emergency brake from the lever on a back brake shoe.
8. Take the fixing bracket of fastening of a cover of a cable of the emergency brake to a brake board.
9. Take a cable of the emergency brake from a brake board.
10. Installation is made in the sequence, the return to removal.
11. Check smoothness of movement and adjust a cable of the emergency brake.
12. Install the central console.