Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
- 3. Engines
   3.1. Technical characteristics
   3.2. Operations on repair of the engine installed in the car
   3.3. Top dead point of the first cylinder
   3.4. Cover of a head of the block of cylinders
   3.5. Inlet collector
   + 3.6. Gear belt and pulleys
   3.7. Replacement of a forward sealing ring of a bent shaft
   3.8. Replacement of sealing rings of camshafts
   3.9. Camshafts and pushers
   3.10. Heads of the block of cylinders
   3.11. Oil pallet
   3.12. Oil pump
   3.13. Drive flywheel / plate
   3.14. Replacement of a back sealing ring of a bent shaft
   3.15. Suspension bracket of the power unit
   + 3.16. Capital repairs of the engine
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


2d841be8


3.15. Suspension bracket of the power unit

GENERAL INFORMATION

Arrangement of a nut of fastening of the right support of the engine


Arrangement of a nut of fastening of the left support of the engine

Check

PERFORMANCE ORDER
1. For improvement of access to a suspension bracket of the power unit lift a forward part of the car and record on supports.
2. Check a condition of rubber elements of a suspension bracket for existence of cracks, aging and stratification.
3. Check reliability of fastening of engine mounts.
4. Moving the engine here and there, check a side play in engine mounts. New elements of a suspension bracket have to have an insignificant side play even.

Replacement

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator. Using the load-lifting mechanism, support the engine.
2. Unscrew nuts of fastening of a support of the engine to a beam (see rice. Arrangement of a nut of fastening of the right support of the engine, Arrangement of a nut of fastening of the left support of the engine).
3. Using the load-lifting mechanism, slightly raise the engine.
4. Unscrew two bolts fixing an engine support to the block of cylinders and remove an engine support.
5. Establish the support located between the engine and a beam and fix by bolts.
6. Slowly lower the engine, at the same time two lower racks have to pass in the corresponding opening in a beam. Tighten bolts of fastening of support of the engine to a beam.