Subaru Legacy

since 1990-1998 release

Repair and operation of the car


Subaru Legacy
+ 1.1. Identification numbers
- 2. Maintenance
   2.1. Introduction
   2.2. Technical characteristics
   2.3. Frequency of service
   2.4. Check of level of engine oil
   2.5. Level of cooling liquid
   2.6. Level of brake fluid and liquid of the drive of coupling
   2.7. Liquid for a windshield washer
   2.8. Check of the accumulator
   2.9. Tires and check of pressure in tires
   2.10. Check of level of oil in the automatic transmission
   2.11. Check of level of liquid in the amplifier of steering
   2.12. Replacement of oil and oil filter
   2.13. Check and service of the accumulator
   2.14. Accumulator charging
   2.15. Check of the cooling system
   2.16. Check of hoses, tubes and their replacement
   2.17. Check and replacement of brushes of screen wipers
   2.18. Shift of tires
   2.19. Check of a suspension bracket and steering
   2.20. Check of the exhaust system
   2.21. Check of level of oil in the transmission and the main transfer
   2.22. Check of level of oil in differential (the main transfer)
   2.23. Check of the brake system
   2.24. Check of the vacuum amplifier of brakes
   2.25. Check of the emergency brake
   2.26. Check of fuel system
   2.27. Replacement of the fuel filter
   2.28. Check and replacement of a driving belt
   2.29. Check of a free wheeling of a pedal of a brake
   2.30. Check of a free wheeling of a pedal of coupling
   2.31. Check and replacement of spark plugs
   2.32. Check of high-voltage wires
   2.33. Check and adjustment of turns of idling
   2.34. Replacement of the air filter
   2.35. Check and replacement of the valve of ventilation of a case (PCV)
   2.36. Check of system of catching of vapors of fuel
   2.37. Check of system of repeated combustion of exhaust gases (EGR)
   2.38. Service of the cooling system
   2.39. Replacement of brake fluid
   2.40. Replacement of oil in the automatic transmission
   2.41. Replacement of oil in the mechanical transmission
   2.42. Check and adjustment of gaps of valves
   + 2.43. Main malfunctions
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


2d841be8

2.39. Replacement of brake fluid
GENERAL INFORMATION
Prevention

Old brake fluid has more dark color, than new.

Operation on replacement of brake fluid is similar to operation of pumping of brakes except that the tank of brake fluid has to be exempted from old brake fluid.

PERFORMANCE ORDER
1. Open the first union of pumping and swing a brake pedal until old brake fluid goes out of the main brake cylinder. Add brake fluid to max tag in a tank and pump over once again before emergence in the union of pumping of new brake fluid then screw up the pumping union. Similarly pump over brake contours of other wheels.
2. When carrying out pumping do not allow lowering of level of brake fluid in a tank below min tag. Otherwise air can get to the hydraulic brake system. Check reliability of tightening of unions of pumping. Establish on them dustproof caps and wipe traces of brake fluid.
3. Check operation of the brake system at the movement of the car at a small speed.