Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
- 14. Electric equipment
   - 14.1. Body electric equipment
      14.1.1. Introduction
      14.1.2. Electric chains
      14.1.3. Detection of not closed chain
      14.1.4. Safety locks
      14.1.5. Chain breakers
      14.1.6. Relay
      14.1.7. Relay of turns and alarm light system
      14.1.8. Multipurpose switches of a steering column
      14.1.9. Ignition lock
      + 14.1.10. Replacement of switches of the dashboard
      14.1.11. Combination of devices
      14.1.12. Radio receiver
      14.1.13. Loudspeakers
      14.1.14. Antenna
      14.1.15. The antenna with the electric drive
      14.1.16. Replacement of bulbs of headlights
      14.1.17. Adjustment of light of headlights
      14.1.18. Headlight
      14.1.19. Replacement of bulbs of an incandescence
      14.1.20. Screen wiper engine
      14.1.21. Sound signal
      14.1.22. Check of a heater of back glass
      14.1.23. Window regulators with the electric drive
      14.1.24. Rear-view mirrors with the electric drive
      14.1.25. Safety airbag
   + 14.2. Electrical circuitries


2d841be8


14.1.17. Adjustment of light of headlights

GENERAL INFORMATION

Arrangement of screws of adjustment of light of headlights on models from 1990 to 1994


Arrangement of screws of adjustment of light of headlights on models since 1995


The correct adjustment of light of headlights is of great importance for traffic safety. Exact adjustment is possible only by means of the special device.

For adjustment of light of headlights the screws located in a back part of a headlight are used. The internal screw is intended for adjustment of light of headlights in the horizontal plane, and the external screw – for adjustment in the vertical plane.

Adjustment of light of headlights can be made at the turned-on passing beam in night-time.

Install the car on a plain horizontal surface opposite to a vertical wall or the screen at distance of 7,5 m and make adjustment of light of headlights according to the scheme.